Mine Shuttle Car Maintenance
Note: The wheel set, traction rod and sliding plate should be lubricated every shift.
A. General Maintenance Principles
Regular maintenance is required to extend the service life of machine. Although the structure of the mine shuttle car is relatively simple, this doesn’t mean the maintenance should be ignored. (Read More)

Mine Shuttle Car Operation
Brief Introduction
The mine shuttle car should be used together with other equipment for moving and transporting. It can be used in the following way:
(1) Connect several mine shuttle cars with each other by flexible traction rods;
(2) The traction engine draws the front flexible traction rod;
(3) Put the scrapper conveyor in parallel;
(4) Unload the slag by side dumping or rear-end dumping. (Read More)

Mine Shuttle Car Technical Description
A. Bogie (Mine Shuttle Car Chassis)
Brief introduction
(1) The low gravity center of bogie makes it easy to adjust the balance of the mine shuttle car.
(2) Each bogie has four wheels, and these wheels can land steadily on the steel rail and move with high flexibility.
(3) Each bogie can turn 360°. (Read More)

Mine Shuttle Car Notes
1. Working conditions
(1) The height above sea level should be lower than 1000m.
(2) The mean temperature should be no higher than 35℃.
(3) The relative temperature of air should be lower than 25℃.
(4) No corrosive gas, steam or dust exists in the surrounding medium that may bring damage. (Read More)